NORSAN
POLYURETHANE FLOOR PAINT INSTRUCTIONS FOR USE back
to top
Ensure the floor is clean and completely free from wax, grease,
dirt etc. Work the seal into the floor to ensure maximum penetration.
Allow 6-8 hours for drying between coats at normal room temperature.
Ensure good ventilation. This assists drying and disperses solvent
vapour. Apply one or two coats preferably by brush or roller.
We would recommend the application of two coats.
This material is not suitable for application to either newly
laid concrete surfaces or to asphalt floors. Newly laid concrete
should be left for a period of one month per inch thickness, prior
to application of the paint, It is recommended that test patches
should be applied prior to coating of large areas to check the
suitability and cleanliness of the substrate. Previously painted
floors and areas of loose/dusty concrete should be mechanically
abraded to provide a firm surface for the paint. Heavy traffic
should be avoided on newly painted surfaces for a period of 72
hours after painting.
Drying Time at 20oC: Surface Dry: 1 hour. Hard Dry: 4 hours. Overcoat
after 6-8 hours. Drying times 'will be extended at low temperatures,
Do not apply where ambient temperatures fall below 3oC or relative
humidity exceeds 90%.
Dry Film Thickness: 15-40 microns. Wet Film Thickness 40-105 microns.
Covering Capacity: Approximate Practical 12 sq. Metres per litre
at 25 microns dry film thickness. )
NORSAN
POLYURETHANE FLOOR PAINT DATA back
to top
Handling
precautions:
Keep the container tightly closed. Exclude sources of heat, sparks
and open flame. Non-sparking tools should be used. Electrical
equipment should be protected to the appropriate standard. Avoid
skin and eye contact. Avoid inhalation of vapour and spray mist.
For personal protection see Exposure Controls Personal Protection.
Prevent the creation of flammable or explosive concentrations
of vapour in the air and avoid vapour concentrations higher than
the occupational exposure. Never use pressure to empty: The container
is not a pressure vessel.
KEEP OUT OF REACH OF CHILDREN.
First aid treatment
In the event of inhalation remove to fresh air. Keep the patient
warm and at rest. If breathing is irregular or stopped, administer
artificial respiration. Give nothing by mouth, if unconscious
place in the recovery position and seek medical advice. In the
event of contact with skin, remove contaminated clothing and wash
skin thoroughly with soap and water. Do NOT use solvents
or thinners. In the event of contact with eyes, Contact lenses
should be removed. Irrigate copiously with clean fresh water for
at least 10 minutes, holding the eyelids apart and seek medical
advice. If ingested obtain immediate attention. Keep at rest.
Do NOT Induce vomiting.
TO PRINT THIS PAGE Press
(Control + P) on a PC or (Option + P) if using a Mac back
to top
