NORSAN POLYURETHANE Oil modified floor seal
Product Number CN2105 Clear

General Description: Norsan Polyurethane is specially prepared for the sealing of wood, cork. composition, concrete and granolithic floors, The sealer produces a hard wearing non-porous surface that enables the floor to be cleaned easily.

NORSAN POLYURETHANE INSTRUCTIONS FOR USE back to top

Ensure floor is clean and completely free from wax. grease, dirt etc. Work the seal into the floor to ensure maximum penetration. Allow 6-8 hours for drying between coats at normal room temperature. Ensure good ventilation. This assists drying and disperses solvent vapour. Number of coats depends on porosity of floor. Two coats will normally be sufficient. Apply by brush or roller applicator. 40-60 square metres per 5 litres.

IMPORTANT NOTE: Before sealing new concrete or similar surfaces. makes certain the floor has thoroughly dried out and is suitable for sealing.

NORSAN POLYURETHANE DATA back to top

Handling precautions:Keep away from sources of ignition - no smoking. Ensure good ventilation, in high vapour concentrations use respiratory protection. Avoid contact with skin. Use barrier cream on exposed areas. Use protective gloves and clothing. Protect and avoid contact with eyes. Wear protective glasses or face shield. Do not swallow. When using do not eat, drink or smoke.
KEEP OUT OF REACH OF CHILDREN.

First aid treatment

In the event of inhalation remove to fresh air. If symptoms continue seek medical attention and if unconscious turn into recovery position. In the event of contact with skin. remove contaminated clothing and wash skin thoroughly with soap and water. In the event of contact with eyes. flush with plenty of water for at least 10 minutes. Seek medical attention. If ingested, do not induce vomiting. give 2 glasses of water to drink. If patient vomits, turn to recovery position. Seek medical advise.


TO PRINT THIS PAGE Press (Control + P) on a PC or (Option + P) if using a Mac back to top