STAR 2000 Concentrated floor maintainer/floor finis
Product Number N26105

General Description: Star 2000 is a combination of high powered cleaning agents together with specially prepared Thermoplastic additives to ensure good protection, and to enhance the gloss of Starshine floor dressing.

Use Star to clean the floor on a regular basis, diluted to the correct concentration, either by damp mopping, automatic scrubber-driers or light spray cleaning.

The floor can then be buffed with high or ultra speed (1500-2500 rpm) machines if desired, which will produce a very high gloss: antislip finish.

If the floor starts to lose its lustre or looks soiled. Lightly scrub with Star to a clean condition without completely removing all the treatments.

When the floor is dry apply a coat of concentrated Star and burnish when dry. In heavy traffic areas a further coat of Star may be necessary.

Providing the above system is adhered to stripping should be a thing of the past. Star can be used neat on certain types of floor coverings to achieve a satin finish.

STAR 2000 INSTRUCTIONS FOR USE back to top

Recommended for use on: Vinyl, Vinyl Asbestos, Thermoplastic, Asphalt, Linoleum, Rubber, Brick, Composition, Terrazzo, Marble, Finished Concrete, Quarry Tiles, Ceramic Tiles and all sealed Wood and Cork floor.

STAR 2000 INSTRUCTIONS FOR USE back to top

Dust control all floor surfaces before cleaning programme starts.

DAMP MOPPING TREATED FLOORS: Half a cupful (100ml) of Star in 5 litres of water. When dry, buff if a higher gloss is required.

DAMP MOPPING UNTREATED FLOORS: one cupful (200rnl) of Star in 5 litres of water. gradually reduce the concentration when a gloss starts to appear. If a higher gloss is desired, buff daily with a high or ultra speed machine. Buffing produces a high gloss finish.

The frequency has to be decided upon according to the conditions prevailing. When choosing the correct floor pad for cleaning programme maintenance of the Norsan 2000 Super System, Norsan recommends using a lighter grade pad than normal.

SPRAY BUFFING OR SPRAY CLEANING TREATED FLOORS: Use Star at a dilution of 50ml to a 600ml spraygun, then fill with water.

SPRAY BUFFING OR SPRAY CLEANING ON UNTREATED FLOORS: Use 300ml in a 600ml spraygun. When gloss satisfaction is reached gradually reduce the concentration.

AUTOMATIC SCRUBBER DRIERS: Daily maintenance is half a cupful (100ml) of Star in 10 litres of water. In the case of heavy traffic a stronger solution may be used.

STAR AS A FLOOR FINISH: Make sure the floor surface is thoroughly cleaned from previous treatments by using Starstrip. Then apply two neat coats evenly on the floor surface. Buff between coats when dry using a soft pad.

Daily maintenance will vary according to the traffic conditions If a satin finish is required do not buff.

STAR APPLIED NEAT ON WORN EMULSION FLOOR DRESSINGS: First make sure the floor surface is clean, then apply 1 or 2 coats on the worn area. Buff when dry, using a soft pad, then apply a further coat over the whole floor area. When this is dry. buff the floor to produce a high gloss finish. For even better results use an ultra speed machine.

STAR 2000 HEALTH DATA back to top

Handling precautions:Avoid contact with skin. May cause irritation to sensitive skin if frequent contact with unprotected skin. Wear protective gloves. Avoid contact with eyes.
This product should not be ingested.
KEEP OUT OF REACH OF CHILDREN.

First aid treatment

In the event of contact with skin, wash with copious quantities of water.
In the event of contact with eyes. wash with copious quantities of water.
In the event of ingestion, drink plenty of water and seek medical advice.


TO PRINT THIS PAGE Press (Control + P) on a PC or (Option + P) if using a Mac back to top